Lift sling rigging company produce Heavy Duty Nylon Flat Webbing Cargo Net,Uena Uena Uena Paha Nylon,Nylon webbing cargo net,Flat Nylon Sling Lifting Net,Nylon Flat Webbing Netting,Heavy-Duty Cargo Bungee Net,Heavy-Duty Cargo Net with Ratchet,Polyester Webbing Cargo Lifting Net.
Heavy Duty Nylon Flat Webbing Cargo Net
An open lattice of flat high-tenacity nylon bands that lifts like a wire rope net, weighs a fraction of one, and leaves the cargo unmarked.

Lift Sling Rigging Company weaves the band, stitches the net and proof-tests every one in Taizhou, ʻO Jiangsu. Band width runs from 25 mm i 100 mm, mesh mai 50 mm i 300 mm, and the rated capacity of a single net from 0.5 t i ka 10 t e like me ke kūlana, with heavy-duty nets built to order well beyond that — the tens-of-tonnes class is a build, not a catalogue item.
No ke aha ka nylon, and why flat webbing
Three things separate this construction from a rope net: the shape of the bearing face, ka pulupulu, and the way the load is shared.
- Pāpā pālahalaha, maka ākea. A 50 mm band lies against the cargo along its whole width. A wire rope touches on a line a few millimetres wide and concentrates everything into it — that is what dents a painted panel or bursts a paper sack.
- Nylon takes the shock. Nylon (PA) stretches further before it parts than polyester, so a load that lands or swings is absorbed rather than transmitted to the hook. Where the lift is a steady, repetitive crane cycle, polyester is the lower-stretch choice; where the cargo is slammed down on a quay, nylon is the more forgiving net.
- Load shared across the lattice. Every band under the load carries a share, so the net does not depend on four hard points. That is also why the same net can hold a bag stack, a pallet of bricks or a bundle of plate without repacking it.

What “tens of tonnes” actually means
A 30 t net is not a 3 t net made bigger. Capacity is built up from four things, and each of them has to move together:
| Load band | Bana / kūkulu | Mesh | Nā wahi hāpai | What else changes |
|---|---|---|---|---|
| 0.5 – 2 t | 25–50 mm single layer | 50–100 mm | 4 kihi | One-person handling, light cargo, bags and small parts |
| 2 – 5 t | 50 mm single layer, double-stitched border | 100 mm | 4 kihi | The standard port and warehouse net |
| 5 – 10 t | 50–75 mm, duplex bands on the load-bearing run | 100 mm | 4 kihi, 8 ma ke noi | Heavier border, reinforced loops, thicker stitch pattern |
| 10 – 30 t | 75–100 mm duplex, band count set by the load face | 100–150 mm | 8 points | Spreader beam or master link in the assembly; net built to drawing |
| 30 t a maluna | 100 mm duplex or multi-layer, band spacing engineered to the load | 150–200 mm | 8 points or more | Built and proof-tested to the lift, certificate per net |
Load bands and build steps are our standard practice; the rating of any net above 10 t is fixed by its own proof test, and we quote it from that certificate.
The arithmetic behind it is plain: a band has a certified strength, the load face has a known number of bands beneath it, and the assembly is rated at the lowest of the band run, the corner loops, the master link and the sling above it. Add bands, widen them, double them, and the net grows; but the corner loops and the hardware have to grow with it, which is why the big nets are designed as a whole rather than bought by the metre.
Flat webbing against wire rope
This is the comparison buyers usually arrive with, and it is worth stating plainly — including where the wire net still wins.
| Nylon flat webbing net | Uena ukana kaula kaula | |
|---|---|---|
| Contact with the cargo | Pāpā pālahalaha, maka ākea, hoailona ole | Hoʻopili laina, marks and dents |
| Effect on packaging | Paper sacks, cartons and shrink wrap survive | Sacks burst, cartons crush at the rope line |
| Kaumaha | One person carries and folds a 2.5 × 2.5 m net | Needs two people and lifting gear |
| ʻAiʻino | Rust-free, suited to quays and offshore decks | Needs galvanised or stainless rope |
| Edge and cut resistance | Maikaʻi loa, but sharp plate and flame need a sleeve or pad | Very high — the reason wire nets survive scrap yards |
| Hoʻoponopono | Re-stitch or replace a band; no swaging | Cut and re-splice by a rigger |
| Handling noise and injury risk | Quiet, no wire spikes | Loud, and wire spikes cut gloves |

Hōʻike
The table is the standard nylon flat webbing net. Laulā kaha, layer count, makaʻu, nui ʻupena, lifting points and printing are all made to order, so read it as the starting point for a quotation rather than a fixed catalogue.
| ʻĀpana | Hōʻike |
|---|---|
| ʻAno | Open flat webbing lattice, no closed bottom; four or eight lifting points |
| Band material | 100 % kiʻekiʻe-tenacity nylon (PA); poliester (PET) or polypropylene (PP) ma ke noi |
| Laulā kaha | 25 / 30 / 50 / 75 / 100 mm |
| Mānoanoa pūʻali | 1.5 – 3.2 mm ma muli o ka laulā |
| Band layer | hoʻokahi, or duplex (papa ʻelua) for abrasion resistance and higher capacity |
| Wehe maka | 50 – 300 mm; 100 × 100 mm maʻamau |
| Mesh form | Square (maʻamau) or diamond on request |
| Upena nui | 1.0 × 1.0 m i ka 4.0 × 4.0 m kūlana; 2.5 × 6 m and any size to drawing |
| Hiki ke koho ʻia | 0.5 – 10 t kūlana; heavier nets built to order and rated from their own proof test |
| Mea palekana | 7:1 |
| Ka palena a me nā kihi | Folded double-stitched border; reinforced lifting loops, four or eight |
| kalakala | ʻAlani kūlana kiʻekiʻe-ʻike; polū, ʻeleʻele, ʻōmaʻomaʻo a maʻamau |
| Lapaʻau | UV-resistant and anti-aging; abrasion-resistant finish |
| Hana wela | −40 °C i +100 °C (poliester); nylon lower at the top end — tell us the duty |
| Hoailona | WLL, nui ʻupena, mesh and date stitched on a label; WLL and brand printable on the band |
| Palapala hōʻoia | CE / GS / HE / ISO 9001 hana; breaking-load test on our own 1000 t mīkini |
| HS code | 630790 |
Standard sizes
| Upena nui | Kaha maʻamau | Typical load |
|---|---|---|
| 1.0 × 1.0 m | 0.5 – 2 t | ʻāpana mīkini, pahu pahu, nā pallets liʻiliʻi |
| 2.5 × 2.5 m | 2 – 5 t | Palletised a ʻeke ukana, container work |
| 2.5 × 6 m | 4 – 10 t | ukana lōʻihi, pipe and plate bundles, truck beds |
| 4.0 × 4.0 m | 5 – 10 t | ʻeke nui, stacked sacks, ukana deck |
| Hana ʻia i ke kaha kiʻi | 10 t and well above | Hold, flat rack, spreader and plant dimensions |

Where the soft face pays for itself
- Painted and coated steel — plate packs, paipu uhi, galvanised sections: no rope line to score the finish.
- Bagged and boxed cargo — fertiliser, cement, palaoa, resin: the flat band does not cut into the bag.
- Machined and plated parts — no dent, no wire mark, no rework before dispatch.
- Marine and offshore transfer — rust-free, Hana ʻia ʻo UV, quiet on a moving deck.
- ʻO ka pahu pahu a me ka hoʻopau ʻana — light enough to pull around the cargo and fold away afterwards.

It is not the right tool everywhere, a he mea pono ke olelo pela: a webbing net is not a scrap-yard net. Sharp plate edges, torn steel and hot slag will cut or burn a band. Where the cargo is sharp, the net is supplied with edge sleeves or a heavier wear band, and the sleeves are inspected with the net.
Rigging it so the load stays inside the mesh
- Lay the net out flat, set the load down inside the mesh and keep it clear of the border — the border is stitch, not bearing face.
- Gather all the lifting loops onto the hook, master ring or spreader; never lift on fewer loops than the net was built with.
- With eight points, use a spreader or two matched slings so the load is shared evenly; a net pulled from four points only will lift less than its rating allows.
- Square the mesh under the load before taking up slack, so the bands line up with the load face instead of pulling diagonally.
- Never drag a load sideways with the net, and never use it as a tow or lashing substitute for a load it was not rated for.
Hoailona, printing and identification
Every net leaves with a sewn label carrying the working load limit, ka nui o ka upena, the mesh and the date. On top of that the band itself can be printed — WLL, net number, fleet code and your own brand — which matters where a yard runs a hundred nets and needs to know at a glance which one is which, and where an inspector needs the rating without hunting for a tag.
Nānā a hoʻomaha
- Read the label before the lift and confirm the load is inside the rating for the way the net is rigged.
- Check every load-bearing band for cuts, abrasion, hoʻopaʻa kemika, heat glazing and broken stitching; check the border and the loops most carefully — that is where wear starts.
- Check the printing is still legible: an unreadable WLL is a net out of service.
- Retire the net if a band, the border or a loop is damaged, or if the mesh has been distorted by an overload. Never knot, weld or heat-repair a webbing net.
- E kūʻai maʻemaʻe a maloʻo, mai ka lepo a ma waho o ka lā pololei, and have the net examined by a competent person at the interval your site sets.

Nīnau pinepine ʻia
Can a webbing net really lift tens of tonnes?
ʻAe, as a build rather than a stock item. Bands get wider and duplex, the band count under the load face goes up, lifting points go from four to eight, and a spreader or master link joins the assembly. Each net of that class is proof-tested and its WLL is taken from the test, so ask for the certificate rather than a catalogue figure.
Will it mark painted or galvanised cargo?
No — that is the main reason buyers move from wire rope to webbing. The band presents a flat, soft face over its full width; a wire net concentrates the same load on a line a few millimetres wide. What a webbing net will not tolerate is a sharp edge, which is what the sleeves are for.
Nylon a i ʻole polyester?
Nylon for shock and impact — slamming a load down, rough quay handling, cargo that swings. Polyester where the lift is steady and repetitive and you want the least stretch under load. Polypropylene for wet or chemical duty and where weight matters most.
What mesh should I take?
100 × 100 mm covers bags, nā pōhaku lepo, pahu, nā pahu a me nā mea liʻiliʻi. Go smaller (50–75 mm) for loose small parts, and larger (150–200 mm) on big heavy nets where band strength matters more than containment.
How is the capacity proven?
Every net is breaking-load tested on our own 1000 t machine and supplied with a capacity label and a material test report; our works hold CE, GS, JIS and ISO 9001 palapala hōʻoia, and the test facilities are CNAS and DNV recognised.
Can you print our brand and the WLL on the band?
ʻAe. WLL, nui ʻupena, fleet number and your own brand can be printed along the band, with a sewn label as well. That is the usual request from distributors and from yards that run a fleet of nets.
Noi mai i ka olelo
Hoʻouna i ka ukana, not just a size
The cargo — what it is, pehea i hoʻopaʻa ʻia ai, and its weight as presented for the lift;
The load face — length × width, and whether the net must contain it or only hold it together;
The lifting arrangement — four or eight points, makau, master ring or spreader, and the sling above;
The environment — quay, ipu, offshore deck, or a coated and painted product;
The paperwork — CE marking, test report and own-brand printing if you need them.
Kahi e hele ai
- Upena hāpai ukana — the polyester version, 2–10 t, 50 mm bana;
- Nylon flat webbing net — the full lattice range, 25–100 mm band;
- ʻO ka maʻa ʻupena ukana naylon kaumaha — closed bottom for loose cargo;
- Web cargo net a the whole cargo lifting net range;
- Nā maʻa kaula uwea where a hard, cut-resistant sling is the right answer;
- Upena kaula palekana for fall protection rather than lifting.