Lift sling rigging company produce Synthetic Fiber Lifting Belt Slings,synthetic lifting belt,Sling nâng tổng hợp,Heavy-Duty Lifting Belt.
Synthetic Fiber Lifting Belt Slings
Polyester, nylon, polypropylen, aramid and UHMWPE: the fibre decides whether the sling survives the job, and the form decides how it meets the load.

Công ty Lift Sling Rigging dệt dây đeo, forms the eyes and proof-tests the sling in Taizhou. This page is about the part of the specification that decides whether a sling survives the job at all — the fibre — and about the two forms it is made into.
The two forms, from the same fibre family
The brief calls for flat belt or round slings, and both are built from the same fibres. The form changes how the load is contacted and how the sling is handled; it does not change what the fibre can survive.
| Flat webbing belt sling | Vòng treo (vô tận) | |
|---|---|---|
| Mặt cắt ngang | Flat band, 25–300 mm rộng | Tròn, sleeved core, 30–100 mm diameter |
| Contact on the load | Widest face; the least pressure per area | Narrower line contact, but soft and compliant |
| Phù hợp ở đâu | Finished flat surfaces, đĩa, coated sheet, bagged cargo | Đường ống, ống, nhẫn, anything that a flat band would crease on |
| Damage visibility | Cuts and abrasion are visible on the face | Damage hides inside the sleeve until it is severe |
| Đánh dấu | Printed along the band, easy to read | Label on the sleeve; colour on the sleeve |
| Typical rating | 0.5 – 24 t trở lên, per build | 1 – 50 t trở lên, per build |

The five fibres, and what each one buys
Every synthetic sling on the market is one of a handful of fibres. They differ in strength per kilo, in how far they stretch, in the temperature they tolerate and in what chemicals attack them — and the differences are large enough to decide the application.
| Chất xơ | Sức mạnh / cân nặng | Kéo dài | Nhiệt | Chemicals and UV | Nó thắng ở đâu |
|---|---|---|---|---|---|
| Polyester (THÚ CƯNG) | Cao | Thấp | −40 đến +100 °C | Good against acids; UV stable | The default: nâng chung, coated and painted work, colour-coded bands |
| Nylon (PA) | Cao | Cao (absorbs shock) | Lower at the top end than polyester | Bị tấn công bởi axit; moderate UV | Shock loads, rough handling, cargo that must settle into the sling |
| Polypropylen (PP) | Vừa phải | Vừa phải | The lowest of the family | Excellent against most chemicals and alkalis; phao | Wet docks, nhà máy hóa chất, nhiệm vụ nhẹ nhàng, cost-sensitive work |
| Aramid | Rất cao | Rất thấp | 200 °C liên tục, 400 đỉnh °C | Poor UV; moderate chemicals | Công việc nóng bỏng, foundry and steel plant, anything near heat |
| UHMWPE | The highest per kilo | Rất thấp | Low — heat is its weakness | Good chemicals; poor at high temperature | Maximum strength for minimum weight, long heavy lifts |
Heat figures are the ones we publish for the aramid webbing; for the other fibres the limit depends on the build, and the label states what the article was rated to.
Two of these rows are worth reading twice. Aramid is the only fibre on the list that will stand in front of hot work — our aramid webbing is rated 200 °C continuous and 400 °C peak with an LOI of 28 or above — but it is also the weakest of the five in sunlight. UHMWPE gives the most strength for the least weight, and then fails earlier than polyester as the temperature climbs. Neither is a general-purpose substitute for the other.

Why the soft face is the whole point
The reason a synthetic sling replaces a wire rope is geometry rather than strength. MỘT 50 mm band and a 10 mm rope carrying the same 5 t present the same force over five times different a contact area — the band presses on the load at roughly a fifth of the pressure, and it does it with a woven surface instead of a steel one.
- Sơn, mạ, coated and polished surfaces arrive at the other end as they left;
- Bagged and boxed cargo is not cut through at the sling line;
- No broken wires to catch a hand, no meat hooks, no kinking — the sling folds away;
- A band of the same rating weighs a fraction of the rope and can be carried by one person.

Matching the fibre to the environment
The tonnage is the easy part. What removes a synthetic sling from service is the environment, and the fibre is the only defence against it.
| Môi trường | Fibre to specify | Tại sao |
|---|---|---|
| General workshop, painted or machined work | Polyester | Độ co giãn thấp, UV stable, the widest availability |
| Loads that land or swing | Nylon | Stretch absorbs the shock instead of passing it to the hook |
| Quay, wet dock, nhà máy hóa chất | Polypropylen | Indifferent to water and to most chemicals; it floats |
| Next to heat, slag or hot plate | Aramid | The only fibre rated for continuous heat in this family |
| Maximum load for minimum weight | UHMWPE | Highest strength per kilo; accept the lower heat ceiling |
| Outdoor storage, long term | Polyester | The most UV-stable of the five |
| Mixed or unknown duty | Polyester | The safest default; specify up when the duty is known |
Rating is per hitch, and the label wins
No synthetic sling has a single capacity. The marked working load limit applies to the arrangement it is used in, and the arrangement is what changes on the floor.
| Sắp xếp | Nhân tố | Nó có nghĩa là gì |
|---|---|---|
| Thẳng đứng | 1.0 | Một chân, straight up — the marked figure |
| Nghẹt thở | 0.8 | Làm tròn tải và quay lại qua mắt của chính nó |
| Rổ, 0–45° | 2.0 | Băng dưới tải, chân gần thẳng đứng |
| Rổ, 45–60° | 1.4 | Same basket, legs spread — the spread costs capacity |
| Hai chân, 0–45° | 1.4 | A matched pair to one hook |
| Hai chân, 45–60° | 1.0 | The pair with the legs spread |
| Ba hoặc bốn chân, 0–45° | 2.1 | Not three or four times the figure; the load rarely shares evenly |
| Ba hoặc bốn chân, 45–60° | 1.5 | The same arrangement, spread |
The angle is measured from the vertical. The label on the sling overrides this table wherever the two disagree.
What a given width carries
Width is the other half of the specification: it sets the pressure on the load and the figure the band can be marked at. The ladder below is the one we publish for the standard build, so a quotation can be read against it.
| Giới hạn tải làm việc | Belt width | Usual ply | Typical end |
|---|---|---|---|
| 1 t | 30 mm | Đơn | Flat loop or folded eye |
| 2 t | 60 mm | Đơn | Flat loop or folded eye |
| 3 t | 90 mm | Đơn | Folded eye |
| 4 t | 120 mm | Two-ply | Folded or reinforced eye |
| 5 t | 150 mm | Two-ply | Folded or reinforced eye |
| 6 t | 180 mm | Two-ply | Mắt gia cố |
| 8 t | 240 mm | Two-ply | Mắt gia cố |
| 10 t | 300 mm | Four-ply | Mắt gia cố |
Read it with the mode factors above and a lift resolves quickly. MỘT 6 t band in a vertical hitch is a 180 mm polyester belt with a reinforced eye. Giống nhau 6 t in a choke is not: cái 0.8 factor takes the capacity to 4.8 t, so the next size up carries it. Move the same job beside a furnace and the width stays but the fibre changes — aramid — because polyester would be the wrong answer however wide it is.
Where a synthetic sling must not go
Honesty here saves a load. The same softness that protects the cargo is what limits the article, and three conditions end it quickly:
- Các cạnh và gờ sắc nét. A cut band starts as a notch. Either the band is sleeved at the works, or the corner carries a pad — and the sleeve has to be ordered with the sling, because it cannot be retro-fitted to a woven band.
- Heat beyond the fibre. Standard synthetic webbing fails by melting, không phải bằng cách biến dạng một cách lịch sự. Above the working limit the answer is aramid, a heat sleeve, or a chain.
- Chemicals the fibre cannot take. Acids attack nylon; strong alkalis and some solvents attack polyester. Where the load is wet with something aggressive, the fibre is chosen for that chemical, not for the tonnage.
How the sling is built and marked
- The band is woven from high-tenacity fibre to the specified width, then cut and formed into eyes or a loop; multi-ply builds layer two or more bands for heavier working limits.
- Eyes are folded and double-stitched in a pattern that puts the thread in shear; reinforced eyes add a wear layer where the hook sits.
- Each sling is proof loaded before dispatch and fitted with a label carrying the working load limit, chiều dài, the fibre and the batch.
- The band itself can be printed — WLL, chiều dài, fleet number and your own brand — and the colour follows the market convention: 1 t tím, 2 màu xanh lá cây, 3 màu vàng, 4 t màu xám, 5 màu đỏ, 6 t nâu, 8 t màu xanh, 10 màu cam. The colour is a quick check; nhãn là câu trả lời.

Kiểm tra và nghỉ hưu
- Read the label before the lift and confirm the sling is rated for the arrangement in use;
- Check the whole band for cuts, trở ngại, vết thủng, mài mòn, heat glazing and chemical staining — an acid or caustic burn is a retirement, not a stain;
- Check the eyes and the stitching most carefully: broken or worn stitching retires the sling;
- Check for distortion of the eyes or fittings after an overload;
- Bảo quản sạch sẽ và khô ráo, ngoài ánh sáng mặt trời, and keep the record with the sling.

Thường xuyên hỏi
Which fibre should I take for a general workshop?
Polyester, unless the duty says otherwise: it stretches little, tolerates UV far better than aramid or UHMWPE, and is available in every width and rating. Move to another fibre only when a specific condition — shock, nhiệt, hóa chất, weight — rules polyester out.
Aramid or UHMWPE for a hot application?
Aramid. It is rated 200 °C continuous and 400 đỉnh °C; UHMWPE has the lowest heat ceiling of the family, so it is the wrong answer next to hot work however strong it is.
Can a round sling replace a flat belt sling?
On pipe, ống, rings and anything that a flat band would crease on, yes — and it is often kinder. On flat finished surfaces the belt gives the wider contact. Both are made from the same fibres, so choose the form by the load’s shape, not by the tonnage.
Does the colour tell me the fibre?
KHÔNG. Colour codes the working load limit by convention, not the material — a yellow sling is 3 t whether it is polyester or nylon. The fibre is on the label.
Why does my nylon sling stretch so much?
Because nylon stretches further before it parts, which is exactly why it is chosen for shock loads: the stretch absorbs the jolt instead of passing it into the hook and the crane. Where a level load matters more than shock, polyester is the better fibre.
Can these slings be used outdoors?
Polyester and polypropylene yes, with normal care; aramid and UHMWPE degrade in prolonged sunlight, so they are stored out of it. In every case, inspect for condition rather than against a calendar.
Yêu cầu báo giá
Gửi nhiệm vụ, không chỉ là trọng tải
The load — what it is, what its surface is worth, and how it will be hitched;
The figure — working load limit needed, and the arrangement it will be used in;
The environment — heat, hóa chất, Nước, Ánh sáng mặt trời, mài mòn, cạnh sắc nét;
The form — flat belt or round sling, and the end type: flat loop, folded or reinforced eye;
The marking — WLL, chiều dài, fleet number and your own brand if you need them printed.
Đi đâu tiếp theo
- The webbing sling range — widths, ends and mode factors in detail;
- Multi-ply webbing slings Và single-ply eye-eye slings;
- Aramid flame-retardant webbing for hot work;
- Cáp treo tròn where the load suits a round, soft cross-section;
- Dây treo nâng vô tận Và the flat webbing sling factory;
- Dây cáp treo where a hard, cut-resistant sling is the right answer, Và contact.