Lift sling rigging company produce Single Ply Endless Lifting Sling,Single Ply Endless Sling,single ply Endless webbing sling,Single-Ply Endless Flat Sling.
Single Ply Endless Lifting Sling
Lera le le leng, one lapped joint, ha ho pheletso. The lightest closed loop in the range: it folds into a pocket, turns a tight radius and drapes over the load — 1 t ho 12 t ho 7:1 pedi NTWE 1492-1.

The word to be careful with is ply. It does not mean two slings or two bands in parallel; it means how many layers of webbing are woven into the one band the loop is made from. Single ply is one layer, and everything that follows — the 4 mm section, the weight per metre, the way it turns round a small radius, and the capacity it can be given at a given width — comes from that one decision.
What one layer actually gives you
Four practical differences separate the single-layer loop from the duplex build, and each one shows up on a different job:
- A 4 mm section. The band folds into a pocket, coils onto a hook and passes between a load and a tight gap where a thicker band will not go.
- Less weight per metre. The ladder below runs from 0.20 kg/m ho 1 t ho 2.05 kg/m ho 10 t — a one-handed carry for the sizes most yards actually use.
- More supple over a radius. One layer conforms to pipe, tube and rolled sections instead of standing off them, so contact is over the full width rather than at two edges.
- Kopano e le 'ngoe, thin and easy to read. The lapped joint is the only made connection in the load path; in a single layer the stitching rows sit on one visible face, with no second layer masking them.

Single ply against duplex, at the same width
The two builds are not two grades of the same thing; they are two answers to different questions. The comparison below is the one we use in quotation, and the widths are the published single-ply ladder.
| Ply e le 'ngoe | Duplex | |
|---|---|---|
| Layers in the band | E 'ngoe | Tse peli, woven as one band |
| Section thickness | 4 mm at the standard ladder | Roughly twice the single-ply section |
| Capacity at a given width | The ladder figure | Higher — the reason duplex exists above the single-ply range |
| Boima ba mithara | 0.20 kg/m ho 1 t ho 2.05 kg/m ho 10 t | Higher for the same width |
| Ho tshoara | Folds small, turns a tight radius, drapes onto the load | E thatafetse; sits flatter over an edge and resists abrasion longer |
| Moo e hlolang | Ka tlase hoo e ka bang 6 t, tight gaps, bophara bo nyane, mixed rigs | High capacity in a narrow width, rough edges, heavy abrasion |
| Kopanetsoeng | One lap, stitching visible on the face | One lap through the doubled band |
The duplex build has its own page: double ply endless lifting sling.
The capacity ladder, ply e le 'ngoe
Working load limits are quoted in straight lift, ho 7:1 pedi NTWE 1492-1. Colour follows EN 1492-1 and is a capacity band, not a material; hodimo 10 t there is no colour code and the label is the only rating.
| SEBELE, phahamisa ka kotloloho | Mmala | Bophara ba litšupiso | Length range | Hoo e ka bang. boima | Qhetsoe (× 0.8) |
|---|---|---|---|---|---|
| 1 t | Violet | Netefatsa ka taelo | 0.5 - 100 m | 0.22 kg/m | 0.8 t |
| 2 t | Botala | 50 mm | 1 - 100 m | 0.35 kg/m | 1.6 t |
| 3 t | Bosehla | 75 mm | 1 - 100 m | 0.52 kg/m | 2.4 t |
| 4 t | Hlooho | 100 mm | 1.5 - 100 m | 0.80 kg/m | 3.2 t |
| 5 t | Khubedu | 125 mm | 1.5 - 100 m | 0.85 kg/m | 4.0 t |
| 6 t | Brown | 150 mm | 1.5 - 100 m | 0.96 kg/m | 4.8 t |
| 8 t | Putsoa | 200 mm | 2 - 100 m | 1.34 kg/m | 6.4 t |
| 10 t | namunu | 250 mm | 2 - 100 m | 1.64 kg/m | 8.0 t |
| Ka holimo 10 t | Ha ho na khoutu ea mebala | Duplex build | Ho laela | Ka kopo | Label e laola |
Widths and weights are the published series for this range; the finished width, ply and weight are confirmed on the order acknowledgement.
Bophara, safety factor and the same capacity
A higher safety factor needs a wider band for the same working load limit, which is why the width column has three values. Tell us the standard your site works to and the sling is built to it; the figures below are the single-ply polyester ladder.
| SEBELE | Ho 5:1 | Ho 6:1 | Ho 7:1 | Botenya | Boima ho 7:1 |
|---|---|---|---|---|---|
| 1 t (1 000 kg) | 25 mm | 25 mm | 30 mm | 4 mm | 0.20 kg/m |
| 2 t (2 000 kg) | 50 mm | 50 mm | 60 mm | 4 mm | 0.60 kg/m |
| 3 t (3 000 kg) | 75 mm | 75 mm | 90 mm | 4 mm | 0.78 kg/m |
| 4 t (4 000 kg) | 100 mm | 100 mm | 120 mm | 4 mm | 0.90 kg/m |
| 5 t (5 000 kg) | 125 mm | 125 mm | 150 mm | 4 mm | 1.14 kg/m |
| 6 t (6 000 kg) | 150 mm | 150 mm | 180 mm | 4 mm | 1.33 kg/m |
| 8 t (8 000 kg) | 200 mm | 200 mm | 240 mm | 4 mm | 1.85 kg/m |
| 10 t (10 000 kg) | 250 mm | 250 mm | 300 mm | 4 mm | 2.05 kg/m |
| 12 t (12 000 kg) | 300 mm | 300 mm | 300 mm | 4 mm | 2.70 kg/m |

Lenonyeletso, and why it is the first thing to look at
An endless sling is endless in use, e se nang morako. The band is lapped over itself and closed with dense parallel rows of stitching; that lap is a full-strength joint and it sits in the load path. It is the only made connection in the whole article.
On a single-layer loop that joint is easier to inspect than on a duplex one, because the stitching rows lie on one visible face rather than between two layers. Look for broken or pulled stitches, a lap that has started to open, and abrasion where the lap passes over an edge. If the joint is sound, the rest of the loop is one continuous band and can be read anywhere along its length.

Three hitches from the same loop
The marked figure is the straight-lift rating; every other arrangement is derived from it. Size the sling to the hitch the crew will actually rig, not to the one in the lift plan.
| Khothatsa | Boemo ba mokhoa | Seo e se bolelang setšeng |
|---|---|---|
| E otlolohileng | × 1.0 | The label figure applies directly |
| Qhetsoe | × 0.8 | A 4 t larisa ka khama hloka a 5 t sling — the wrap grips as the load comes on |
| Baskete, maoto a pela tse otlolohileng | × 2.0 | Both sides of the loop carry the load and the bearing face is doubled |
| Baskete, 7°–45° | × 1.4 | As the legs open the rating falls; plan the angle, not only the weight |
| Baskete, 45°–60° | × 1.0 | At wide angles the basket advantage is gone — treat it as a straight lift |
Bolelele: selikalikoe, or the height you actually get
Loop e koetsoeng ha e na lipheletso, kahoo ha ho letho le lekanyang qetello ho isa qetellong. This trade quotes the same sling two ways, mme di fapana ka ntlha ya tse pedi: the circumference is the perimeter of the loop, while the effective working length is the usable height you get, roughly half the circumference because the loop is doubled when it hangs.
| E qotsitsoe joalo ka | Seo e se lekanyang | Lehae le tšoanang lea lekana |
|---|---|---|
| Potoloho | The perimeter of the loop — total band in the article | 2 m |
| Bolelele bo sebetsang bo sebetsang | Bophahamo bo ka sebediswang; the loop doubles when it hangs | 1 m |
Name the convention with the figure, kapa bolela tšebeliso ho e-na le hoo - karolo ea sehlooho eo lupu e tlamehang ho pota-pota - 'me ho se hlaka hoa nyamela pele sehlopha se khaoloa..

Polyester, and the limits of it
The standard build is 100% polyester e phahameng haholo (PES). It elongates no more than 3% at the working load limit and no more than 10% moroalo o robehileng, so the load does not creep down as the lift comes on, and the standard build works from −40 °C to +100 °C. Nylon is offered where shock and abrasion dominate; polypropylene where weight and cost matter more than strength; UHMWPE and aramid where strength-to-weight or heat is the deciding factor.
What ends a polyester build is the same list as for any synthetic sling: heat above the range, strong alkalis, sharp edges that cut rather than abrade, and a cut or a glaze anywhere on the circumference. On a closed loop there is no second end to compare, so condition is judged against the surrounding band.

Marking and traceability
- IN 1492-1 capacity colour in the weave — violet 1 t, botala 2 t, mosehla 3 t, bohlooho 4 t, khubelu 5 t, sootho 6 t, putsoa 8 t, namunu 10 t.
- One black transverse stripe per tonne as a second, optical check on the band itself.
- A sewn label with the working load limit, thepa, maemo, length and traceability code — and above 10 t, the label is the only rating there is.
- Every sling proof tested in our own laboratory before dispatch, with a test certificate per batch on request; HS khoutu 630790.

E botsoa khafetsa
What does single ply mean, exactly?
One layer of webbing in the band the loop is made from — not two slings, and not two bands side by side. It gives a 4 mm section at the standard ladder widths, the lowest weight per metre in the range, and the most supple loop we build.
Is an endless sling seamless?
Che. Ha e felle ka tšebeliso, e se nang morako: the band is lapped over itself and closed with dense parallel stitching, and that lap is a full-strength joint in the load path. What a closed loop removes is the eyes and the end fittings, not the joint. If you need a closed loop with no joint in the load-bearing element at all, ke eona letjeketjane le sa feleng, where the core is continuous.
How far up the capacity range does single ply go?
The single-ply ladder is published to 12 t ho 7:1 in a 300 sehlopha sa mm; the range as a whole runs to 30 t, and above the single-ply ladder the duplex build is the answer rather than a wider single band.
Can I use one loop for a vertical lift and a choke?
Ee, and the figure changes with the arrangement: 1.0 e otlolohileng, 0.8 khangoa, 2.0 in a basket with the legs near vertical, oela ho 1.4 and then 1.0 as the legs open. Size to the hitch the crew will actually rig.
Will a single ply sling mark aluminium or painted steel?
The band is synthetic fibre and no fitting touches the load, so it will not scratch or burr the way a chain or a wire rope can. Width is the protection measure — for mirror-finish or anodised work, specify a width above the capacity ladder and the pressure on the surface falls with it.
How should the length be quoted?
Ka ho potoloha kapa ka bolelele bo sebetsang ba ho sebetsa - tse peli li fapana ka ntlha ea tse peli. Bolela kopano, or give the girth of the article the loop must go round, and the figure is confirmed on the order acknowledgement.
Kopa qotso
Five things settle a single ply loop
The load — what it is, its girth at the pick positions, and its surface;
The hitch — vertical, khangoa kapa seroto, and the leg angle if it is a basket;
The working load limit in that hitch, and the safety factor your site works to;
The length — with its convention, or the girth the loop has to go round;
The marking and packing — own-brand label, carton or pallet specification.
Moo u lokelang ho ea teng
- The endless lifting sling range — every closed form, compared by load;
- Lesela le le leng le le leng le sa feleng le letjeketjane le bataletseng le polyester endless flat strap sling for the full size and weight tables;
- Double ply endless lifting sling where the capacity needs to go up at the same width;
- Lesela le sa feleng la marang-rang le letjeketjane le sa feleng for the type A article in full;
- Leqhoele la ho phahamisa lipeipi tsa tšepe bakeng sa mosebetsi oa liphaephe, le the one-way single ply version for single-trip export packing;
- Li-slings tsa marang-rang in all builds, le contact.