起重吊索具公司生产重型 20 Ton Polyester Cargo Lifting Net,10Ton Cargo Lifting Net,30T Cargo Net,50Tonne Lifting Net,20Tonne Cargo Net,
重负 20 Ton Polyester Cargo Lifting Net
一个 20 t working load limit at 7:1: wide duplex polyester bands, eight lifting points and a rating that comes off the test bed, not off a table.

We build these nets to order in Taizhou: band width and layer, 网, 净尺寸, lifting points and printing are set from the load, and each net is proof tested on our own bed before it leaves with its capacity label and material test report.
Why polyester at this rating
在 20 t the net is under load for a long time and usually lifted many times a week, so stretch matters more than it does on a one-off lift. That is what decides the fibre.
| 聚酯纤维 (宠物) | 尼龙 (PA) | |
|---|---|---|
| Stretch under a steady load | Low — the net stays square and the load stays level | Markedly higher; the net settles and the load can tilt |
| 减震 | 缓和 | Best in the family; 18–22 % 断裂伸长率 |
| 吸水率 | 很低, dries quickly | 关于 4 %, with some strength loss when saturated |
| Repetitive crane cycles | The usual choice | Better where pickups are rough |
| 工作温度 | −40°C 至 +100 ℃ | Lower at the top end |
| Best fit for a 20 负载 | 袋装, 托盘化的, bundled or stacked cargo lifted on a cycle | Irregular or shocky loads that must settle into the mesh |

What changes when the rating goes to 20 t
Capacity is not a property of the net’s size. It comes from four things moving together: 乐队, the number of load-bearing bands under the load, the corner points, and the hardware the points gather onto.
| Load band | Band and build | 网 | 吊装点 | What else changes |
|---|---|---|---|---|
| 2 – 5 t | 50 mm single layer | 100 毫米 | 4 corners | Standard warehouse net |
| 5 – 10 t | 50 – 75 毫米, duplex on the load run | 100 毫米 | 4 corners, 8 根据要求 | Heavier border, reinforced loops |
| 10 – 20 t | 75 – 100 毫米双工 | 100 – 150 毫米 | 8 points | Master ring or spreader beam; net built to drawing |
| 20 – 30 t | 100 毫米双工, band count from the load face | 150 毫米 | 8 points | Spreader beam in the assembly; proof test per net |
| 多于 30 t | 100 mm multi-layer or wider pitch | 150 – 200 毫米 | 8 points or more | Engineered and tested to the lift, not to a catalogue |
Build steps above 10 t are our standard practice; the rating of any individual net is fixed by its own proof test and quoted from that certificate.
接下来有两个后果. 第一的, the corner loops and the master link or spreader have to be rated for the same 20 t — a net rated 20 t 在 a 10 t ring is a 10 组装. 第二, the same net can be rated differently for four points and eight: the label states the arrangement it was tested in, and lifting it another way changes what it may carry.

Sizing the net to a 20 负载
A lifting net must be bigger than the load, or the cargo sits on the border instead of inside the mesh and the corner loops pull straight up through it.
- Flat form: allow at least 100–150 mm of net beyond the load on every side, and more where the sides are vertical or the load is loose. 一个 2.0 × 2.0 m load therefore takes a net of about 2.3 × 2.3 m or larger.
- 袋子形式: the flat width has to wrap up the sides and close over the top, 所以 flat width = footprint + 2 × bag depth. 一个 1.2 m footprint in a 0.6 m deep bag needs about 2.4 m across.
- Corner legs: the four or eight legs have to reach the hook or master ring without lifting the border off the cargo — a common reason a net that fits the load is still too small for the lift.

网: sized from the cargo, 不是吨位
Mesh decides what cannot escape the net; tonnage decides how strong the bands are. A heavy net with too open a mesh spills small items whatever its rating.
| 最小货物尺寸 | Typical cargo at 20 t | 网格指定 |
|---|---|---|
| 在下面 75 毫米 | Small castings, 散装组件, drummed goods | 100 mm diamond, or a closed bag net |
| 75 – 150 毫米 | 砖块, 袋装货物, 裂石 | 100 – 150 毫米 |
| 150 – 250 毫米 | Sawn packs, bundled tube, 纸箱, 废料 | 150 – 200 毫米 |
| 超过 250 毫米 | 积木, large stone, 拆除碎片 | 200 – 300 毫米 |
规格
| 范围 | 规格 |
|---|---|
| 类型 | 开放式平面织带格子, 四个或八个吊点 |
| 表带材质 | 100 % 高强力聚酯 (宠物); nylon or UHMWPE on request |
| 带宽 | 75 – 100 mm for this class |
| Band build | 复式 (双层) on the load-bearing run, single layer elsewhere |
| 网孔 | 100 – 150 毫米; square standard, diamond on request |
| 净尺寸 | 通常 4.0 × 4.0 米至 6.0 × 6.0 米, or to the load footprint |
| 工作负荷极限 | 20,000 kg in the rated arrangement |
| 安全系数 | 7:1 — 最小破断载荷 140,000 公斤 |
| 边框和角 | Doubled border, 拼接到角落里; reinforced loops, four or eight |
| 配件 | 主环或等级 80 镣铐; spreader beam for eight-point lifts |
| 治疗 | 紫外线稳定, 抗衰老, abrasion-resistant finish |
| 工作温度 | −40°C 至 +100 ℃ |
| 标记 | WLL, 安排, net size and identification on a sewn label; band printing on request |
| 文档 | Capacity label, material test report, CE标志; 我们自己测试过 1000 t bed |
| 海关编码 | 630790 |

Eight points, 不是四个, once the load is long
Twenty tonnes gathered onto four corner loops means each loop carries about 5 t before any angle is taken into account; from eight points it is 2.5 t each, and the load face stays square instead of bowing in the middle. That is why an eight-point net is paired with a spreader beam or a master link rather than hung from a single hook.
- Four points suit square, compact loads where the net is only holding the cargo together;
- Eight points suit long or wide loads, and any lift where the net must stay flat under load;
- The spreader or master link, the slings above it and the hook must each be rated at least 20 t;
- Never lift from fewer points than the net was rated for, and never knot or shorten a leg to take up slack.
The leg sees more than the share: 在 45 deg from the vertical, 一个 2.5 t share becomes about 3.5 t along the leg (2.5 / cos 45), which is why the slings above the net are sized from the angle, not from the load divided by eight.
检查和报废
| 查看 | Retire or repair if |
|---|---|
| Corner loops and their stitching | A loop is deformed, the stitching is broken, or the band is cut at the throat |
| 边界 | The border is cut, flattened, or has pulled out of a corner |
| Load-bearing bands | Any band is cut, 严重磨损, heat glazed or chemically stained |
| Mesh geometry | The lattice is distorted from an overload — the net no longer sits square |
| 拼接 | Stitch lines are broken or pulled at a crossover |
| Label and printing | The WLL or the arrangement is illegible — an unlabelled net cannot be rated |
Inspect before each lift and have the net examined by a competent person at the interval your site sets. Store it clean and dry, 远离地面且避免阳光直射; never knot, weld or heat-repair a webbing net.

它是如何建造的, and how the rating is proven
- Bands woven, not cut from sheet. The webbing is woven to width and stitched into the lattice at the crossover points, with the stitch pattern set so the thread takes shear rather than peel.
- Lattice laid square. The mesh is set out from the drawing before stitching, so the bands under the load line up with the load face instead of running diagonally.
- Border spliced into the corners. The doubled border carries the load from corner to corner, so no single stitch line carries the lift; the loops are formed out of the border.
- Proof tested, then labelled. Each net is loaded on our own bed and fitted with a label stating the working load limit, the arrangement it was tested in and the net number.
The same works weaves webbing and presses wire rope ferrules, which is why a net, 一个 织带吊带 和一个 钢丝绳吊索 on the same lift can be matched in rating rather than bought from three suppliers.
其中一个 20 t net does the work
| 部门 | 网提升了什么 | Usual build |
|---|---|---|
| 钢铁和制造 | 捆绑包, 部分, stillage loads | 平网, 100 毫米双工, eight points |
| 石头和采石场 | 积木, 裂石, cobbles | 袋子形式, 150 毫米网目, corner patches |
| 港口和码头 | Bagged and unitised cargo, quay work | Flat net on a spreader, 打印的WLL |
| 木材 | Sawn packs, 两极, sleepers | Flat or bag, 150 – 200 毫米网目 |
| 废料和回收 | 混合和磨料废料 | Large mesh, wear bands at the corners |
| 预制混凝土 | Units, 戒指, 面板 | Flat net with edge sleeves, eight points |
常见问题
是 20 t rating for the net or for the whole assembly?
The net is rated 20 t in the arrangement it was tested in — four or eight points, on the fittings supplied. The assembly as lifted is limited by its weakest part, so the master link, 镣铐, spreader and slings above must be rated at least 20 t as well.
Why is the safety factor 7:1 而不是 5:1?
7:1 is the factor we build to for this class, which gives a 140 t 最小破断载荷 20 t 等级. Where a site works to 5:1, say so at enquiry and the net is built to that factor instead — the rating on the label always states what it was made to.
Polyester or nylon for a 20 吨电梯?
Polyester where the load is lifted on a cycle and must stay level — its lower stretch keeps the net square. Nylon where the pickup is shocky or the cargo is irregular and has to settle into the mesh; it stretches far more, which absorbs the jolt but lets the load tilt.
How big a net do I need for a 2 × 2 m load?
At least 2.3 × 2.3 m to give 150 mm of overhang on every side, plus enough corner leg to reach the hook without pulling the border up over the cargo. Send the footprint and the hook height and the leg length is worked out from those two.
Can it be lifted by a single hook?
Yes on four points, where the four loops gather on a master ring under the hook. On eight points a single hook would pull the net into a cone, so a spreader beam or a two-leg arrangement is used instead.
Can you print our brand and the WLL on the net?
Yes — WLL, 安排, 净尺寸, fleet number and your own brand can be printed along the band, with a sewn label as well. Yards running a fleet of nets usually ask for it.
索取报价
Send the load and how it is presented
The cargo — what it is, 它是如何包装的, and the weight as presented for the lift;
The footprint — length × width, plus height if a bag form is needed;
The lift — four or eight points, 吊钩高度, and whether a spreader beam is available;
The duty — how many lifts a week, indoors or on a quay, and the temperature range;
The paperwork — CE marking, test report and own-brand printing if you need them.
下一步去哪里
- 织带货物吊装网 — the standard 2–10 t range;
- Heavy duty nylon flat webbing net — the same lattice in nylon;
- 尼龙绳货物吊装网 — rope construction to 50 t;
- Heavy duty cargo net sling — closed bottom for loose cargo;
- 提升吊具梁 for eight-point lifts;
- The whole cargo lifting net range 和 contact.