升降吊帶索具公司生產重型 20 Ton Polyester Cargo Lifting Net,10Ton Cargo Lifting Net,30T Cargo Net,50Tonne Lifting Net,20Tonne Cargo Net,
重型 20 Ton Polyester Cargo Lifting Net
一 20 t working load limit at 7:1: wide duplex polyester bands, eight lifting points and a rating that comes off the test bed, not off a table.

We build these nets to order in Taizhou: band width and layer, 網格, 淨大小, lifting points and printing are set from the load, and each net is proof tested on our own bed before it leaves with its capacity label and material test report.
Why polyester at this rating
喺 20 t the net is under load for a long time and usually lifted many times a week, so stretch matters more than it does on a one-off lift. That is what decides the fibre.
| 聚酯 (寵物) | 尼龍 (PA) | |
|---|---|---|
| Stretch under a steady load | Low — the net stays square and the load stays level | Markedly higher; the net settles and the load can tilt |
| 減震 | 溫和 | Best in the family; 18–22 % 斷裂時嘅伸長率 |
| 吸水性 | 好低, dries quickly | 關於 4 %, with some strength loss when saturated |
| Repetitive crane cycles | The usual choice | Better where pickups are rough |
| 工作溫度 | −40 °C 至 +100 °C | Lower at the top end |
| Best fit for a 20 t 負載 | 有袋裝, 托盤化, bundled or stacked cargo lifted on a cycle | Irregular or shocky loads that must settle into the mesh |

What changes when the rating goes to 20 t
Capacity is not a property of the net’s size. It comes from four things moving together: 樂隊, the number of load-bearing bands under the load, the corner points, and the hardware the points gather onto.
| Load band | Band and build | 網格 | 升降點 | What else changes |
|---|---|---|---|---|
| 2 – 5 t | 50 mm single layer | 100 毫米 | 4 corners | Standard warehouse net |
| 5 – 10 t | 50 – 75 毫米, duplex on the load run | 100 毫米 | 4 corners, 8 根據要求 | Heavier border, reinforced loops |
| 10 – 20 t | 75 – 100 毫米雙層 | 100 – 150 毫米 | 8 points | Master ring or spreader beam; net built to drawing |
| 20 – 30 t | 100 毫米雙層, band count from the load face | 150 毫米 | 8 points | Spreader beam in the assembly; proof test per net |
| 上面 30 t | 100 mm multi-layer or wider pitch | 150 – 200 毫米 | 8 points or more | Engineered and tested to the lift, not to a catalogue |
Build steps above 10 t are our standard practice; the rating of any individual net is fixed by its own proof test and quoted from that certificate.
跟住有兩個後果. 第一, the corner loops and the master link or spreader have to be rated for the same 20 t — a net rated 20 t 喺 a 10 t ring is a 10 t 組裝. 第二, the same net can be rated differently for four points and eight: the label states the arrangement it was tested in, and lifting it another way changes what it may carry.

Sizing the net to a 20 t 負載
A lifting net must be bigger than the load, or the cargo sits on the border instead of inside the mesh and the corner loops pull straight up through it.
- Flat form: allow at least 100–150 mm of net beyond the load on every side, and more where the sides are vertical or the load is loose. 一 2.0 × 2.0 m load therefore takes a net of about 2.3 × 2.3 m or larger.
- 袋形式: the flat width has to wrap up the sides and close over the top, 所以 平闊 = 足跡 + 2 × bag depth. 一 1.2 m footprint in a 0.6 m deep bag needs about 2.4 m 對面.
- Corner legs: the four or eight legs have to reach the hook or master ring without lifting the border off the cargo — a common reason a net that fits the load is still too small for the lift.

網格: sized from the cargo, 唔係噸位
Mesh decides what cannot escape the net; tonnage decides how strong the bands are. A heavy net with too open a mesh spills small items whatever its rating.
| 最細嘅貨物尺寸 | Typical cargo at 20 t | 要指定嘅網格 |
|---|---|---|
| 下面 75 毫米 | 小鑄件, 散裝嘅組件, drummed goods | 100 毫米鑽石, 或者係一個封閉嘅袋網 |
| 75 – 150 毫米 | 磚, 袋裝貨品, 劈開嘅石頭 | 100 – 150 毫米 |
| 150 – 250 毫米 | Sawn packs, bundled tube, 紙箱, 銷毀 | 150 – 200 毫米 |
| 超過 250 毫米 | 塊, 大石頭, 拆除碎片 | 200 – 300 毫米 |
規格
| 參數 | 規格 |
|---|---|
| 種類 | 打開平坦嘅網格, 四、八個升降點 |
| 樂隊材料 | 100 % 高韌性聚酯 (寵物); nylon or UHMWPE on request |
| 頻段寬度 | 75 – 100 mm for this class |
| Band build | 雙面 (雙層) on the load-bearing run, single layer elsewhere |
| 網格開口 | 100 – 150 毫米; square standard, diamond on request |
| 淨大小 | 通常 4.0 × 4.0 m 到 6.0 × 6.0 米, or to the load footprint |
| 工作負荷限制 | 20,000 kg in the rated arrangement |
| 安全因素 | 7:1 — 最小斷裂負荷 140,000 公斤 |
| 邊框同角落 | Doubled border, spliced into the corners; reinforced loops, four or eight |
| 配件 | 主戒指或者等級 80 枷鎖; spreader beam for eight-point lifts |
| 治療 | 紫外線穩定咗, 抗衰老, abrasion-resistant finish |
| 工作溫度 | −40 °C 至 +100 °C |
| 標記緊 | WLL, 安排, net size and identification on a sewn label; band printing on request |
| 文件 | Capacity label, 材料測試報告, CE 標記; 我哋自己測試過 1000 t bed |
| HS 代碼 | 630790 |

Eight points, 唔係四個, once the load is long
Twenty tonnes gathered onto four corner loops means each loop carries about 5 t before any angle is taken into account; from eight points it is 2.5 t each, and the load face stays square instead of bowing in the middle. That is why an eight-point net is paired with a spreader beam or a master link rather than hung from a single hook.
- Four points suit square, compact loads where the net is only holding the cargo together;
- Eight points suit long or wide loads, and any lift where the net must stay flat under load;
- The spreader or master link, the slings above it and the hook must each be rated at least 20 t;
- Never lift from fewer points than the net was rated for, and never knot or shorten a leg to take up slack.
The leg sees more than the share: 喺 45 deg from the vertical, 一 2.5 t share becomes about 3.5 t along the leg (2.5 / cos 45), which is why the slings above the net are sized from the angle, not from the load divided by eight.
Inspection and retirement
| 檢查 | 退休或者修理如果 |
|---|---|
| Corner loops and their stitching | A loop is deformed, the stitching is broken, or the band is cut at the throat |
| 邊界 | 邊框被剪咗, flattened, or has pulled out of a corner |
| Load-bearing bands | Any band is cut, 深深磨損, heat glazed or chemically stained |
| Mesh geometry | The lattice is distorted from an overload — the net no longer sits square |
| 縫紉 | Stitch lines are broken or pulled at a crossover |
| Label and printing | The WLL or the arrangement is illegible — an unlabelled net cannot be rated |
Inspect before each lift and have the net examined by a competent person at the interval your site sets. 儲存佢乾淨同乾燥, 離地同埋避開陽光直射; never knot, weld or heat-repair a webbing net.

How it is built, and how the rating is proven
- Bands woven, not cut from sheet. The webbing is woven to width and stitched into the lattice at the crossover points, with the stitch pattern set so the thread takes shear rather than peel.
- Lattice laid square. The mesh is set out from the drawing before stitching, so the bands under the load line up with the load face instead of running diagonally.
- Border spliced into the corners. The doubled border carries the load from corner to corner, so no single stitch line carries the lift; the loops are formed out of the border.
- Proof tested, then labelled. Each net is loaded on our own bed and fitted with a label stating the working load limit, the arrangement it was tested in and the net number.
The same works weaves webbing and presses wire rope ferrules, which is why a net, 一 繩索吊帶 同埋一個 鐵絲繩吊帶 on the same lift can be matched in rating rather than bought from three suppliers.
邊度 a 20 t net does the work
| 部門 | 網抬起啲咩 | 平時嘅建造 |
|---|---|---|
| 鋼鐵同製造 | 捆綁, 部分, 靜止負荷 | Flat net, 100 毫米雙層, eight points |
| Stone and quarry | 塊, 劈開嘅石頭, 鹽石 | 袋形式, 150 毫米網格, 角落貼片 |
| 端口同終端機 | Bagged and unitised cargo, quay work | Flat net on a spreader, 印咗 WLL |
| 木材 | Sawn packs, 極, sleepers | Flat or bag, 150 – 200 毫米網格 |
| 廢料同回收 | Mixed and abrasive scrap | 大網狀, wear bands at the corners |
| Precast concrete | Units, 戒指, 面板 | Flat net with edge sleeves, eight points |
經常問
係個 20 t rating for the net or for the whole assembly?
The net is rated 20 t in the arrangement it was tested in — four or eight points, on the fittings supplied. The assembly as lifted is limited by its weakest part, so the master link, 枷鎖, spreader and slings above must be rated at least 20 t as well.
Why is the safety factor 7:1 而唔係 5:1?
7:1 is the factor we build to for this class, which gives a 140 t 最小斷裂負荷為 a 20 t 評分. Where a site works to 5:1, say so at enquiry and the net is built to that factor instead — the rating on the label always states what it was made to.
Polyester or nylon for a 20 t 升降機?
Polyester where the load is lifted on a cycle and must stay level — its lower stretch keeps the net square. Nylon where the pickup is shocky or the cargo is irregular and has to settle into the mesh; it stretches far more, which absorbs the jolt but lets the load tilt.
How big a net do I need for a 2 × 2 m load?
At least 2.3 × 2.3 m to give 150 mm of overhang on every side, plus enough corner leg to reach the hook without pulling the border up over the cargo. Send the footprint and the hook height and the leg length is worked out from those two.
Can it be lifted by a single hook?
Yes on four points, where the four loops gather on a master ring under the hook. On eight points a single hook would pull the net into a cone, so a spreader beam or a two-leg arrangement is used instead.
Can you print our brand and the WLL on the net?
Yes — WLL, 安排, 淨大小, fleet number and your own brand can be printed along the band, with a sewn label as well. Yards running a fleet of nets usually ask for it.
要求報價
Send the load and how it is presented
The cargo — what it is, 佢點樣包裝, and the weight as presented for the lift;
The footprint — length × width, plus height if a bag form is needed;
The lift — four or eight points, 鉤高度, and whether a spreader beam is available;
The duty — how many lifts a week, indoors or on a quay, and the temperature range;
The paperwork — CE marking, test report and own-brand printing if you need them.
下次去邊
- 網狀貨物升降網 — the standard 2–10 t range;
- Heavy duty nylon flat webbing net — the same lattice in nylon;
- Nylon rope cargo lifting net — rope construction to 50 t;
- Heavy duty cargo net sling — closed bottom for loose cargo;
- 抬起散布梁 for eight-point lifts;
- The whole cargo lifting net range 同 contact.